Subaru Legacy: Electronic compass display
By briefly pressing the compass button, the compass display is toggled on or off. When the compass display is on, an illuminated compass reading will appear on the mirror.
Using the electronic compass properly, the following compass zone adjustment and compass calibration will be necessary.
Compass zone adjustment
Compass calibration zones
1. Refer to the “Compass calibration zones” map shown above to verify that the
compass zone setting is correct for your geographical location.
2. Press and hold the compass button for 3 to 6 seconds, and then release it. The
zone number will be shown on the electronic compass display.
3. Press the compass button repeatedly until the correct zone number for your location
is displayed.
4. Releasing the button for 3 seconds will exit the zone setting mode.
Compass calibration
1. For optimum calibration, switch off all nonessential electrical accessories
(rear window defogger, heater/air conditioning system, spotlight, etc.) and ensure
all doors are shut.
2. Drive to an open, level area away from large metallic objects or structures and
make certain the ignition switch is in the “ON” position.
3. Press and hold the compass button for 6 to 9 seconds, and then release it. The
compass will enter the calibration mode, then “C” and the direction will be displayed.
4. Drive slowly in a circle until “C” disappears from the display. Driving in two
or three circles might be necessary. The compass is now calibrated.
5. Further calibration may be necessary should outside influences cause the compass
to read inaccurately. You will notice any outside influence if the compass tends
to read in only one particular direction. Should you encounter this situation, return
to step 1 of the above procedure and recalibrate the compass.
Rear view image display
When the ignition switch is in the “ON” position and the transmission is in the “R” (reverse) position, the rear view camera automatically displays the rear view image behind the vehicle o ...HomeLink® Wireless Control System
The HomeLink® Wireless Control System can be used to activate remote control devices such as gate operators, garage door openers, door locks, home lighting and security systems. There are three ...See also:
English and Metric Unit
Conversion
To change the display units between
English and metric units, see Driver
Information Center (DIC) for more information. ...
Jump Starting
Although this seems like a simple
procedure, you should take several
precautions.
A battery can explode if you do
not follow the correct procedure,
seriously injuring anyone
nearby.
Ke ...
Programming HomeLink for Canadian
customers
Prior to 1992, D.O.C. regulations required handheld
transmitters to stop transmitting after 2 seconds.
To program your hand-held transmitter to
HomeLink , continue to press and hold the
HomeLink b ...