BMW 5 Series: Emergency detection of remote control
It is possible to switch on the ignition or start the engine in situations such as the following:
▷ Interference of radio transmission to remote
control by external sources.
▷ Discharged battery in the remote control.
A Check Control message is displayed if an attempt is made to switch on the ignition or start the engine.
Starting the engine in case of emergency detection of remote control
Starting the engine in case of
emergency detection of remote control
Automatic transmission: if a corresponding Check Control message appears, hold the remote control, as shown, against the marked area on the steering column and press the Start/Stop button within 10 seconds while pressing the brake.
Manual transmission: if a corresponding Check Control message appears, hold the remote control, as shown, against the marked area on the steering column and press the Start/Stop button within 10 seconds while pressing the clutch.
Loss of the remote controls
Lost remote controls can be blocked by your service center. ...Personal Profile
...See also:
Fault tracing and actions
If the message Windscreen Sensors blocked is displayed, this means that the camera
is obscured and cannot detect pedestrians, vehicles or road marker lines in front
of the vehicle.
This, in turn, ...
How Your Side Airbags Work
If you ever have a moderate to
severe side impact, sensors will
detect rapid acceleration and signal
the control unit to instantly inflate
either the driver’s or the passenger’s
side a ...
ENGINE
OVERHEATED — IDLE
ENGINE
This message displays when the
engine coolant temperature is too
hot. Stop and allow the vehicle to
idle until it cools down. ...