Chrysler 200: Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord.
The engine block heater cord is bundled under the hood between the headlight assembly and the Totally Integrated Power Module (Fuse Box) on the driver’s side of the vehicle.
The engine block heater must be plugged in at least one hour to have an adequate warning effect on the engine.
WARNING!
Remember to disconnect the engine block heater
cord before driving. Damage to the 110-115 Volt
electrical cord could cause electrocution.
After Starting
The idle speed will automatically decrease as the engine warms up. ...Automatic Transmission
CAUTION! Damage to the transmission may occur if the following precautions are not observed: • Shift into PARK only after the vehicle has come to a complete stop. • Shift into or out of REV ...See also:
Bluetooth Streaming Audio (BTSA)
Music can be streamed from your cellular phone to the
Uconnect™ phone system.
Controlling BTSA Using Radio Buttons
To get into the BTSA mode, press either “AUX” button on
the radio or pres ...
Headlamps fogged up on the inside
The headlamps may fog up on the inside if
there is high atmospheric humidity.
•► Drive with the headlamps switched on.
The level of moisture diminishes,
depending on the length of the jo ...
Installing top tether strap
INSTALLING TOP
TETHER STRAP
First, secure the child restraint with the Latch lower anchors (rear outboard
seat positions only) or the seat belt, as applicable.
1. Flip up the anchor cove ...