Hyundai Sonata: Engine compartment fuse replacement - Fuses - Maintenance - Hyundai Sonata Owners ManualHyundai Sonata: Engine compartment fuse replacement

Hyundai Sonata / Hyundai Sonata Owners Manual / Maintenance / Fuses / Engine compartment fuse replacement

1. Turn the ignition switch and all other switches off.

1. Turn the ignition switch and all other switches off.
2. Remove the fuse panel cover by pressing the tab and pulling up.
3. Check the removed fuse; replace it if it is blown. To remove or insert the fuse, use the fuse puller in the engine compartment fuse panel.
4. Push in a new fuse of the same rating, and make sure it fits tightly in the clips. If it fits loosely, consult an authorized HYUNDAI dealer.

CAUTION

After checking the fuse panel in the engine compartment, securely install the fuse panel cover. If not, electrical failures may occur from water contact.

Multi fuse

Multi fuse

If the multi fuse is blown, it must be removed as follows:
1. Turn off the engine.
2. Disconnect the negative battery cable.
3. Remove the fuse panel on the right side in the engine compartment.
4. Remove the nuts shown in the picture above.
5. Replace the fuse with a new one of the same rating.
6. Reinstall in the reverse order of removal.

NOTICE

If the multi fuse is blown, consult an authorized HYUNDAI dealer.

    Instrument panel fuse replacement
    1. Turn the ignition switch and all other switches off. 2. Open the fuse panel cover. 3. Pull the suspected fuse straight out. Use the removal tool provided in the engine compartment fuse pane ...

    Fuse/relay panel description
    Inside the fuse/relay panel covers, you can find the fuse/relay label describing fuse/relay name and capacity. Inner panel fuse panel Engine compartment fuse panel NOTICE Not all fuse panel ...

    See also:

    Volume control
    You can adjust the phone call volume, the voice volume and the voice guidance volume. Refer to “Volume control switch” F5-32. Adjustable level of each volume ...

    Engine low oil level warning light
    The engine low oil level warning light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds. This light also illuminates when the en ...

    If the smart key system has been deactivated in a customized setting
    ●Locking and unlocking the doors: Use the wireless remote control or mechanical key. ●Starting the engine and changing “ENGINE START STOP” switch modes. ●Stopping the engin ...