Buick LaCrosse: EPB Apply
The EPB can be applied any time the vehicle is stopped. The EPB is applied by momentarily lifting up on the EPB switch. Once fully applied, the parking brake status light will be on. While the brake is being applied, the status light will flash until full apply is reached. If the light does not come on, or remains flashing, have the vehicle serviced. Do not drive the vehicle if the parking brake status light is flashing. See your dealer. See Electric Parking Brake Light for more information.
If the EPB is applied while the vehicle is in motion, a chime will sound, and a DIC message will be displayed. See Brake System Messages. The vehicle will decelerate as long as the switch is held in the up position.
Releasing the EPB switch during deceleration will release the parking brake. If the switch is held in the up position until the vehicle comes to a stop, the EPB will remain applied.
If the parking brake status light flashes continuously, the EPB is only partially applied or released, or there is a problem with the EPB.
A DIC message will be displayed.
See Brake System Messages. If this light flashes continuously, release the EPB, and attempt to apply it again. If this light continues to flash, do not drive the vehicle. See your dealer.
If the parking brake warning light is on, the EPB has detected an error in another system and is operating with reduced functionality. To apply the EPB when this light is on, lift up on the EPB switch and hold it in the up position. Full application of the parking brake by the EPB system may take longer than normal when this light is on. Continue to hold the switch until the parking brake status light remains on. If the parking brake warning light is on, see your dealer.
If the EPB fails to apply, the rear wheels should be blocked to prevent vehicle movement.
Parking Brake
Parking Brake
The vehicle has an Electric Parking
Brake (EPB). The switch for the
EPB is in the center console. The
EPB can always be activated, even
if the ignition is off. To prevent
dr ...
EPB Release
To release the EPB, place the
ignition in the ON/RUN position,
apply and hold the brake pedal, and
push down momentarily on the EPB
switch. If you attempt to release the
EPB without the brak ...
See also:
Automatic anti-glare mirrors
WARNING
If incident light from headlamps is prevented
from striking the sensor in the rear-view
mirror, for instance, by luggage piled too high
in the vehicle, the mirror's automatic antigl ...
Nissan vehicle immobilizer system
The NISSAN Vehicle Immobilizer system will not allow the engine to start without
the use of the registered key.
If the engine fails to start using a registered key (for example, when interference
...
Effective range (areas within which the electronic key is
detected)
When locking or unlocking
the doors
The system can be operated
when the electronic key is
within about 2.3 ft. (0.7 m) of
either of the front outside
door handles. (Only the
doors dete ...