Chrysler 200: Front Turn Signal
1. Raise and prop open the hood.
2. Rotate the bulb’s electrical connector one-quarter turn counterclockwise and remove it from the headlamp housing.
3. Remove the bulb from the connector socket and install the replacement bulb.
4. Install the bulb and connector assembly into the headlamp housing and rotate the connector one-quarter turn clockwise to lock it in place.
Headlamp
1. Raise and prop open the hood. Locate the connector behind the headlamp. NOTE: It may be necessary to remove the air cleaner filter housing and position the totally integrated power module a ...Front Fog Lamp
NOTE: Access to the lamps through the lower fascia cutout is limited.We recommend you access the lamps by turning the steering wheel to allow access and remove the inner fender shield. 1. Rota ...See also:
Floormat on the driver's side
WARNING
Whenever you are using a floormat, make sure
there is enough clearance and that the
floormat is securely fastened.
The floormat should always be securely
fastened using the fasteni ...
SRS Care
The SRS is virtually maintenance-free and so there are no parts you can safely
service by yourself. If the SRS air bag warning light ""
does not illuminate, when you turn the ignition on ...
Replacing a Front Turn Signal/Parking Light Bulb
1. Open the hood.
To change the turn signal bulb on
the passenger’s side, remove the
engine coolant reserve tank by
pulling it out of its stay.
Driver’s side on V6 models
Remove t ...