Subaru Legacy: Gear position indicator setting (MT models)
The gear position indicator light can be activated or deactivated by performing the following procedure.
1. Turn the ignition switch to the “LOCK” position.
2. Press the trip knob to show “ ” or “ ” on the trip meter display.
The display can be switched as shown in the following illustration by pressing the trip knob.
3. To change the current setting, press the trip knob for at least 2 seconds.
NOTE
● The initial setting for your vehicle of the gear position indicator has been set for activation “” at the time of shipment from the factory.
● It is not possible to change the setting of the gear position indicator when the ignition switch is in the “ON” position. Change the setting when the ignition switch is in the “LOCK” or “Acc” position.
Upshift/downshift indicator (AT and CVT models)
When the manual mode is selected, the gear position indicator (which shows the current gear selection) and the upshift/ downshift indicator light up. Refer to “Automatic transmission/Continuousl ...Turn signal indicator lights
These lights show the operation of the turn signal or lane change signal. If the indicator lights do not blink or blink rapidly, the turn signal bulb may be burned out. Replace the bulb as soon a ...See also:
With Selective Ride Control
1. Move the shift lever to the left
from D (Drive).
The vehicle will be in Sport
Mode. The gear indicator in the
DIC will still display a D for
Drive, and the SPORT MODE
ON message will be ...
Seat Belt
Fastening the Seat Belt
1. Grasp the seat belt tongue.
2. Slowly pull out the lap/shoulder belt.
3. Insert the seat belt tongue into the seat belt buckle until you hear a click
sound.
WARNIN ...