Dodge Avenger: Hazard warning flasher
The Hazard Warning flasher switch is located on theinstrument panel, below the radio.
Press the switch to turn on the Hazard Warningflasher. When the switch is activated, all directionalturn signals will flash on and off to warn oncomingtraffic of an emergency. Press the switch a second time toturn off the Hazard Warning flasher.
This is an emergency warning system and should not beused when the vehicle is in motion. Use it when yourvehicle is disabled and is creating a safety hazard forother motorists.
If it is necessary to leave the vehicle to go for service, theHazardWarning flasher will continue to operate with theignition key removed and the vehicle locked.
NOTE: With extended use, the Hazard Warning flashermay wear down your battery.
If your engine overheats
In any of the following situations, you can reduce thepotential for overheating by taking the appropriate action. • On the highways — Slow down. • In city traffic — While stopped, put tran ...See also:
Headlight control sensor (if equipped)
The sensor may not function properly if
an object is placed on the sensor, or anything
that blocks the sensor is affixed to
the windshield.
Doing so interferes with the sensor
detecting the ...
Beep Sounds
Air Bag/Front Seat Belt Pretensioner System Warning Beep
If a malfunction is detected in both the air bag/front seat belt pretensioner
system and the warning light, a warning beep sound will be hea ...
Operating UHP Using Voice
Control
The voice control of the UHP
system enables you to operate
several functions of the mobile
phone using your voice. The UHP
system uses voice commands to
control the system and dial phone
n ...