Chrysler 200: Headlamp
1. Raise and prop open the hood. Locate the connector behind the headlamp.
NOTE:
It may be necessary to remove the air cleaner
filter housing and position the totally integrated power
module aside prior to replacing the low beam headlamp
on the driver’s side of the vehicle.
2. Reach into engine compartment and from behind the lamp assembly and grasp the connector.
3. Rotate bulb and connector one-quarter turn and pull outward from assembly.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life.
4. Pull the bulb out of the socket and replace the bulb.
5. If the bulb comes in contact with any oily surface, clean the bulb with rubbing alcohol.
6. Reinsert the bulb and socket assembly and rotate clockwise one-quarter turn to secure.
Bulb Replacement
...Front Turn Signal
1. Raise and prop open the hood. 2. Rotate the bulb’s electrical connector one-quarter turn counterclockwise and remove it from the headlamp housing. 3. Remove the bulb from the connector sock ...See also:
MOPAR Parts
MOPAR fluids, lubricants, parts, and accessories are
available from an authorized dealer. They are recommended
for your vehicle in order to help keep the vehicle
operating at its best. ...
System alarm operation
The alarm system will give the following alarms when triggered:
● The vehicle’s horn will sound and the turn signal lights will flash for 30
seconds.
● If any door (or the rear gate/ ...
Tether anchorage location
Legacy
Three tether anchorages are installed on the rear shelf behind the rear seat
head restraint. Open the cover flap to use each anchorage.
Outback
Three tether anchorages, i.e., ones for ...