Nissan Altima: Headlight beam select - Headlight control switch - Headlight and turn signal switch - Instruments and controls - Nissan Altima Owners ManualNissan Altima: Headlight beam select

1 To select the high beam function, push the

1 To select the high beam function, push the lever forward. The high beam lights come on and the 2 Pull the lever back to select the low beam. light illuminates.

2 Pull the lever back to select the low beam.

3 Pulling and releasing the lever flashes the headlight high beams on and off.

    Autolight system (if so equipped)
    The autolight system allows the headlights to be set so they turn on and off automatically. The autolight system can: ● Turn on the headlights, front parking, tail, license plate and instr ...

    Battery saver system
    If the ignition switch is placed in the OFF position while the headlight switch is in the or position, the headlights will turn off after 5 minutes. CAUTION Even though the battery saver feat ...

    See also:

    Traction
    When driving on wet or slushy roads, it is possible for a wedge of water to build up between the tire and road surface. This is hydroplaning and may cause partial or complete loss of vehicle con ...

    Tongue load
    Keep the tongue load between 10 - 15 percent of the total trailer load or use the trailer tongue load specified by the trailer manufacturer. The tongue load must be within the maximum tongue load ...

    Steering gear box, linkage & boots/lower arm ball joint
    With the vehicle stopped and engine off, check for excessive free-play in the steering wheel. Check the linkage for bends or damage. Check the dust boots and ball joints for deterioration, cracks, ...