Subaru Legacy: High beam light bulbs - Headlight - Replacing bulbs - Maintenance and service - Subaru Legacy Owners ManualSubaru Legacy: High beam light bulbs

1. Remove the air intake duct (right-hand side). For the method to remove the air intake duct, refer to “Removing air intake duct” F11-7.

Left-hand side

Left-hand side

2. Use a screwdriver to remove the secured clip of the washer tank. To make it easy to access the bulb, move the washer tank to the horizontal direction (left-hand side).

3. Disconnect the electrical connector from the bulb.

3. Disconnect the electrical connector from the bulb.

4. Remove the bulb from the headlight assembly by turning it counterclockwise.

4. Remove the bulb from the headlight assembly by turning it counterclockwise.

5. Replace the bulb with new one. At this time, use care not to touch the bulb surface.

6. Reconnect the electrical connector.

7. To install the bulb to the headlight assembly, turn it clockwise until it clicks.

8. Install the air intake duct with clips (right-hand side).

9. Set the washer tank to the original place and secure it by clip (left-hand side).

    Low beam light bulbs
    1. Pull off the fender lining. For details, refer to “Pulling off the fender lining” F11- 7. 2. Remove the bulb cover, by turning it counterclockwise. 3. Disconnect the electrical connecto ...

    Front turn signal light
    NOTE It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary. 1. Turn over the protective cover of the engine compartment. 2 ...

    See also:

    Voice Recognition
    The voice recognition system uses commands to control the system and dial phone numbers. Noise: The system may not recognize voice commands if there is too much background noise. When to Spe ...

    The front airbag system
    The front airbags supplement the three-point seat belts. For these airbags to provide the protection intended, seat belts must be worn at all times. The front airbag system includes gas generator ...

    Position of the steering wheel for driving
    The steering wheel is moved to the last selected position when:  - the driver's door is closed.  - you insert the SmartKey into the ignition lock. or  - you press the Star ...