Subaru Legacy: High/low beam change (dimmer) - Light control switch - Instruments and controls - Subaru Legacy Owners ManualSubaru Legacy: High/low beam change (dimmer)

To change from low beam to high beam, push the turn signal lever forward. When

To change from low beam to high beam, push the turn signal lever forward. When the headlights are on high beam, the high beam indicator light “on the combination meter is also on.” on the combination meter is also on.

To switch back to low beam, pull the lever back to the detent position.

    Sensor for the auto on/off headlights
    The sensor is on the instrument panel as shown in the illustration. CAUTION If any object is placed on or near the sensor, the sensor may not detect the level of the ambient light correctly and ...

    Headlight flasher
    CAUTION Do not hold the lever in the flashing position for more than just a few seconds. To flash the headlights, pull the lever toward you and then release it. The high beam will stay on for as ...

    See also:

    If the On Indicator is Lit for a Child Restraint
    If a child restraint has been installed and the on indicator is lit: 1. Turn the vehicle off. 2. Remove the child restraint from the vehicle. 3. Remove any additional items from the seat such as bl ...

    Changing wheels and tires
    Mounting Information on mounting tires Have mounting and balancing performed only by a service center or tire specialist. If this work is not carried out properly, there is the danger of subse ...

    Speed-dependent steering force*
    Steering force increases with the speed of the vehicle to give the driver enhanced sensitivity. At low speed the vehicle is easy to steer in order to facilitate parking, etc. Steering force can b ...