Subaru Legacy: How to jump start
1. Make sure the booster battery is 12 volts and the negative terminal is grounded.
2. If the booster battery is in another vehicle, do not let the two vehicles touch.
3. Turn off all unnecessary lights and accessories.
4. Connect the jumper cables exactly in the sequence illustrated.
1) Connect one jumper cable to the positive (+) terminal on the discharged battery.
2) Connect the other end of the jumper cable to the positive (+) terminal of the
booster battery.
3) Connect one end of the other cable to the negative (−) terminal of the booster
battery.
4) Connect the other end of the cable to the strut mounting nut.
Make sure that the cables are not near any moving parts and that the cable clamps are not in contact with any other metal.
5. Start the engine of the vehicle with the booster battery and run it at moderate speed. Then start the engine of the vehicle that has the discharged battery.
6. When finished, carefully disconnect the cables in exactly the reverse order.
Jump starting
WARNING
● Battery fluid is SULFURIC ACID. Do not let it come in contact with the eyes,
skin, clothing or the vehicle.
If battery fluid gets on you, thoroughly flush the exposed area with wat ...
Engine overheating
WARNING
Never attempt to remove the radiator cap until the engine has been shut off and
has fully cooled down. When the engine is hot, the coolant is under pressure. Removing
the cap while the en ...
See also:
Language
Select the Language menu and the
following will be displayed:
• English
• French
• Spanish
Turn the Menu knob to select the
language. Press SELECT to confirm
the selection. Press BACK ...
Vehicle equipment
All standard, country-specific and optional
equipment that is offered in the model series is
described in this chapter. Therefore, equipment
is also described that is not available in a vehicle, ...
