Subaru Legacy: How to preset stations
1. Press the “FM” or “AM” button to select FM1, FM2, FM3 or AM reception. 2. Press the “” or “” side of the “SEEK” button or tune the radio manually until the desired station frequency is displayed. 3. Press one of the preset buttons for more than 1.5 seconds to store the frequency. If the button is pressed for less than 1.5 seconds, the preceding selection will remain in memory.
NOTE
● If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all stations stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset stations. . If a cell phone is placed near the radio, it may cause the radio to emit noise when the phone receives calls. This noise does not indicate a radio malfunction.
Station preset
Preset buttons ...Selecting preset stations
Presetting a station with a preset button allows you to select that station in a single operation. Up to six AM, FM1, FM2 and FM3 stations each may be preset. ...See also:
Seat belt maintenance
Check periodically that the seat belts are in good condition. Use water and a
mild detergent for cleaning. Check seat belt mechanism function as follows: attach
the seat belt and pull rapidly on t ...
Power outlets
The power outlet can be used for 12 V accessories that run on less
than 10 A.
Instrument cluster
Center console (if equipped)
■The power outlet can be used when
Vehicles without a sma ...
REVERSE
This range is for moving the vehicle backward. Shift into
REVERSE only after the vehicle has come to a complete
stop. ...