Subaru Legacy: If the light is blinking
If the light is blinking while driving, an engine misfire condition has been detected which may damage the emission control system.
To prevent serious damage to the emission control system, you should conform to the following instructions.
● Reduce vehicle speed.
● Avoid hard acceleration.
● Avoid steep uphill grades.
● Reduce the amount of cargo, if possible.
● Stop towing a trailer as soon as possible.
The CHECK ENGINE warning light/malfunction indicator lamp may stop blinking and illuminate steadily after several driving trips. You should have your vehicle checked by an authorized SUBARU dealer immediately.
If the light illuminates constantly
If the light illuminates constantly while driving or does not turn off after the engine starts, an emission control system malfunction has been detected. You should have your vehicle checked by an ...Coolant temperature low indicator light/Coolant temperature high warning light
CAUTION ● After turning the ignition switch to the “ON” position, if this indicator light/warning light behaves under any of the following conditions, the electrical system may be malfu ...See also:
Use of engine braking
Remember to make use of engine braking in addition to foot braking. When descending
a grade, if only the foot brake is used, the brakes may start working improperly
because of brake fluid overheat ...
Making adjustments in 5 mph (Canada:
10 km/h) increments
•► Briefly press the cruise control lever
beyond the pressure point, up 1 for a
higher speed or down 2 for a lower speed.
The last speed stored is increased or
reduced. ...
Cleaning the exterior
WARNING:
If you use a car wash with a waxingcycle, make sure that you removethe wax from the windscreen.
CAUTIONS:
Some car wash installations usewater at high pressure. This coulddamage certain pa ...