Nissan Maxima: If your vehicle is stolen
If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink. Consult the Owners Manual of each device or call the manufacturer or dealer of those devices for additional information.
When your vehicle is recovered, you will need to reprogram the HomeLink Universal Transceiver with your new transmitter information.
FCC Notice:
This device complies with FCC rules part 15 and RSS-210 of Industry Canada. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and (2) This device must accept any interference that may be received, including interference that may cause undesired operation.
This transmitter has been tested and complies with FCC and DOC/MDC rules.
Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.
DOC: ISTC 1763K1313.
FCC I.D. CV2V67690.
Reprogramming a single HomeLink button
To reprogram a HomeLink Universal Transceiver button, complete the following.
1. Press and hold the desired HomeLink button.
Do not release the button until step 4 has been completed.
2. When the i ...
See also:
Malfunction Indicator Lamp
A computer system called OBD II (On-Board Diagnostics-Second Generation) monitors operation of the fuel, ignition, and emission control systems. It makes sure that emissions are at acceptable levels f ...
Problems with the engine
Problem
Possible causes/consequences and - Solutions
The engine does not
start. The starter motor
can be heard.
- There is a malfunction in the engine electronics.
...
Wear indicators
1) New tread
2) Worn tread
3) Tread wear indicator
Each tire incorporates a tread wear indicator, which becomes visible when the
depth of the tread grooves decreases to 0.063 in (1.6 mm). A tir ...
