Mercedes-Benz E-Class: installing and removing the seat cushion
You must remove the seat cushion if you wish to lift the trunk floor, e.g. if the vehicle has a flat tire.
•► To remove: fold seat cushion 2 upwards and remove it from seat cushion guides 1.
•► To install: guide seat cushion 2 into seat cushion guides 1 at a slight angle from the rear 3.
•► Fold seat cushion 2 back into its original position 4 until it engages.
Folding out the folding bench seat
•► Make sure that the backrests of the rear bench seat are locked in the upright position. •► Move the handle for the combined cargo cover and net upwards. •► Pull re ...Folding back the folding bench seat
•► Pull the seat cushion upwards by tab 1 and fold it back into its original position until it engages. •► Press release button 1 and fold the head restraints down. In orde ...See also:
USB Port
For vehicles with a USB port, the
following devices may be connected
and controlled by the infotainment
system.
• iPods
• PlaysForSure Devices (PFDs)
• USB Drives
• Zunes™
• USB ...
Engine compartment
CAUTION:
Never use a fuse of a higher or lower amperage rating than specified on the fuse
box cover. This could damage the electrical system or cause a fire.
If any electrical equipment does not ...
Turbo models
1) Air intake duct 2) Air cleaner case 3) Clamp
1. Remove the hydraulic hose in the power steering system from the clip on the
air intake duct.
2. Remove the hydraulic hose from the clip on the ...