Toyota Camry: Installing child restraints using a seat belt (child restraint lock function belt)
■ Rear facing ⎯ Infant seat/convertible seat
Place the child restraint system on the rear seat facing the rear of the vehicle.
Run the seat belt through the child restraint system and insert the plate into the buckle. Make sure that the belt is not twisted.
Fully extend the shoulder belt and allow it to retract to put it in lock mode. In lock mode, the belt cannot be extended.
While pushing the child restraint system down into the rear seat, allow the shoulder belt to retract until the child restraint system is securely in place.
After the shoulder belt has retracted to a point where there is no slack in the belt, pull the belt to check that it cannot be extended.
■ Forward facing ⎯ Convertible seat
Place the child restraint system on the seat facing the front of the vehicle.
Run the seat belt through the child restraint system and insert the plate into the buckle. Make sure that the belt is not twisted.
Fully extend the shoulder belt and allow it to retract to put it in lock mode. In lock mode, the belt cannot be extended.
While pushing the child restraint system into the rear seat, allow the shoulder belt to retract until the child restraint system is securely in place.
After the shoulder belt has retracted to a point where there is no slack in the belt, pull the belt to check that it cannot be extended.
If the child restraint has a top tether strap, the top tether strap should be latched onto the top tether strap anchor.
■ Booster seat
Place the child restraint system on the seat facing the front of the vehicle.
Sit the child in the child restraint system. Fit the seat belt to the child restraint system according to the manufacturer's instructions and insert the plate into the buckle. Make sure that the belt is not twisted.
Check that the shoulder belt is correctly positioned over the child's shoulder and that the lap belt is as low as possible.
Installation with LATCH system
Type A Widen the gap between the seat cushion and seatback slightly. Latch the hooks of the lower straps onto the LATCH anchors. If the child restraint has a top tether strap, the top te ...Removing a child restraint installed with a seat belt
Push the buckle release button and fully retract the seat belt. ...See also:
Advanced Sirius settings
This menu function enables you to make settings on certain Sirius satellite radio
functions. To access this menu:
1. Press OK/MENU.
2. Scroll to the Advanced settings menu and press OK/MENU.
...
Safety Belt Use During Pregnancy
Safety belts work for everyone, including pregnant women. Like all occupants, they are more likely to be seriously injured if they do not wear safety belts.
A pregnant woman should wear a lap-shoul ...
Trunk Release
The trunk may be opened by
pressing on the Remote
Keyless Entry (RKE) transmitter or
the touch pad located on the rear of
the trunk above the license plate.
See Trunk for more
information. ...