Chrysler 200: Intermittent Wiper System
Use the intermittent wiper system when weather conditions make a single wiping cycle with a variable pause between cycles desirable. Rotate the end of the windshield wiper/washer control lever to the first detent, and then turn the end of the lever to select the desired delay interval. There are five delay settings, which allow you to regulate the wipe interval from a minimum of one cycle every second to a maximum of approximately 18 seconds between cycles.
Changing Intermittent Settings
NOTE:
The wiper delay times depend on vehicle speed.
If the vehicle is moving less than 10 mph (16 km/h), delay times will be doubled.
Windshield Wipers And Washers
The wipers and washers are operated by a switch on the control lever. The lever is located on the right side of the steering column. Windshield Wiper/Washer Lever Rotate the end of the lever ...Windshield Washers
To use the washer, pull the windshield wiper/washer control lever toward you and hold it for as long as washer spray is desired. If you activate the washer while the wiper control is in the del ...See also:
Using booster cables
CAUTIONS:
Connect batteries with only the samenominal voltage.
Always use booster cables withinsulated clamps and adequate sizecable.
Do not disconnect the battery fromthe vehicle’s electrical sy ...
Capturing the image
The image is captured by two cameras
integrated in the exterior mirrors and by the
backup camera.
The range equals:
▷ Approx. 7 ft/2 m to the side.
▷ approx. 7 ft/2 m to the rear.
...
Making Turns
Notice:
Making very sharp turns
while trailering could cause the
trailer to come in contact with the
vehicle. The vehicle could be
damaged. Avoid making very
sharp turns while trailering.
...