Buick LaCrosse: License Plate Lamp
The license plate lamps for this vehicle are on the trunk lid.
To replace one of these bulbs:
1. Open the trunk. See Trunk for more information.
2. Push the end on either of the lamp assemblies (passenger side shown) and then move the lamp assembly down to remove it from the trunk lid.
A. Bulb Socket
B. Bulb
C. Lamp Assembly
3. Turn the bulb socket (A) counterclockwise to remove it from the lamp assembly (C).
4. Pull the bulb (B) straight out of the bulb socket.
5. Push the replacement bulb straight into the bulb socket and turn the bulb socket clockwise to install it into the lamp assembly.
6. Move the lamp assembly into the trunk lid, engaging the clip side first.
7. Push on the lamp side opposite the clip until the lamp assembly snaps into place.
Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
A. Back-Up Lamp
B. Turn Signal Lamp
To replace one of these lamps:
1. Open the trunk. See Trunk.
2. Remove the fasteners and pull
back the trunk trim.
3. Remove the four plastic wing
nuts h ...
Replacement Bulbs
For replacement bulbs not listed
here, contact your dealer. ...
See also:
1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution
caused by blow-by gases being emitted from the crankcase. This system supplies fresh
filtered air to the crankcase th ...
Personal lights
Front
Turns the lights on/off
Rear (vehicles with moon roof)
Turns the lights on/off ...
Operation Instructions - (Disc Mode For CD And MP3/WMA Audio Play,
DVD-Video)
The radio DVD player and many DVD discs are coded by
geographic region. These region codes must match in
order for the disc to play. If the region code for the DVD
disc does not match the region ...