Subaru Legacy: Low beam light bulbs
1. Pull off the fender lining. For details, refer to “Pulling off the fender lining” F11- 7.
2. Remove the bulb cover, by turning it counterclockwise.
3. Disconnect the electrical connector.
4. Remove the retainer spring.
5. Replace the bulb, then set the retainer spring securely.
6. Reconnect the electrical connector.
7. Install the bulb cover.
8. After replacing the bulb, reattach the fender lining.
Headlight
CAUTION Halogen headlight bulbs become very hot while in use. If you touch the bulb surface with bare hands or greasy gloves, fingerprints or grease on the bulb surface will develop into hot spot ...High beam light bulbs
1. Remove the air intake duct (right-hand side). For the method to remove the air intake duct, refer to “Removing air intake duct” F11-7. Left-hand side 2. Use a screwdriver to remove the se ...See also:
Braking in Emergencies
ABS allows the driver to steer and
brake at the same time. In many
emergencies, steering can help
more than even the very best
braking. ...
SRS airbag system components
1 Front impact sensors
2 Front passenger occupant classification system (ECU and sensors)
3 Knee airbags
4 Side impact sensors (front door)
5 Side impact sensors (front)
6 Front passenger airba ...
Premium-grade unleaded gasoline
To ensure the longevity and full
performance of the engine, only premiumgrade
unleaded gasoline may be used.
If there is no premium-grade unleaded
gasoline available and regular-grade
unleade ...