Nissan Altima: Making a call
To make a call, follow the procedure below:
1. Press the button on the steering wheel. The “Phone” screen will appear on the display.
2. Select one of the following options to make a call:
● Vehicle Phonebook: Select the name from an entry stored in the vehicle phonebook.
● Handset Phonebook: Select the name from an entry stored in the handset phonebook.
● Call History: Select the name from the incoming or outgoing call history.
● Dial Number: Input the phone number manually using a keypad displayed on the screen.
For information on how to use the touchscreen, see “How to use the touch screen” in this section.
3. For all of the methods listed in Step 2 except “Dial Number”, dialing commences when the listed name is selected. Dialing commences when “OK”is selected if the number is inputted manually. The screen changes to the “Call in Progress” screen.
4. After the call is over, perform one of the following to finish the call:
a. Select the “Hang up” key on the Call in Progress screen.
b. Press the switch on the steering wheel.
Transferring the handset phonebook
If your cellular phone supports automatic downloading, the system transfers the handset phonebook automatically by default. To ensure that this feature is activated, press the SETTING button on th ...Receiving a call
When you hear a phone ring, the display will change to phone mode. To receive a call, follow one of the procedures listed below. a. Select the “Answer” key on the display. b. Press the phone ...See also:
Setting and storing the parking position
You can position the front-passenger side
exterior mirror in such a way that you can see
the rear wheel on that side as soon as you
engage reverse gear. You can store this
position.
•` ...
Radar sensor
Position
Radar sensor
Dirty or covered sensor
A dirty or covered sensor may hinder the detection
of vehicles.
▷ If necessary, clean the radar sensor. Remove
layers of snow and ice care ...
Operating tips
● Say a command after the tone. Voice commands
cannot be accepted when the icon
is .
● If the command is not recognized, the system
repeats the announcement. Repeat the
command in a c ...