Subaru Legacy: P (Park)
This position is for parking the vehicle and starting the engine.
In this position, the transmission is mechanically locked to prevent the vehicle from rolling freely.
When you park the vehicle, first apply the parking brake, then shift into the “P” position. Do not hold the vehicle with only the transmission.
To shift the select lever from the “P” to any other position, you should depress the brake pedal fully then move the select lever. This prevents the vehicle from lurching when it is started.
NOTE
To protect the engine while the “P” position is selected, the engine is controlled such that the engine speed may not become too high even if the accelerator pedal is depressed hard.
Select lever
The select lever has four positions, “P”, “R”, “N”, “D” and also has a manual gate for using the manual mode. ...R (Reverse)
This position is for backing the vehicle. To shift from the “N” to “R” position, stop the vehicle completely then move the lever to the “R” position. ...See also:
Compass display
Press the button when the
ignition switch
is placed in the ON position. The direction will be
displayed. ...
Start
Ignition switch with remote key inserted ( see page 86 for more
information on ignition modes)
WARNING
Before starting the engine:
Fasten the seat belt.
Check that the seat, steering ...
Interior Glass
To clean, use a terry cloth fabric
dampened with water. Wipe droplets
left behind with a clean dry cloth.
Commercial glass cleaners may be
used, if necessary, after cleaning
the interior glas ...