BMW 5 Series: Parking lamps/low beams, headlamp control
General information
If the driver door is opened with the ignition switched off, the exterior lighting is automatically switched off at the following switch settings:
0, ,
Parking lamps
Switch position : the vehicle lamps light up on all sides, e.g., for parking.
Do not use the parking lamps for extended periods; otherwise, the battery may become discharged and it would then be impossible to start the engine.
When parking, it is preferable to switch on the one-sided roadside parking lamps
Low beams
Switch position with the ignition switched on: the low beams light up
Welcome lamps
When parking the vehicle, leave the switch in position or : the parking and interior lamps light up briefly when the vehicle is unlocked.
Activating/deactivating
1. "Settings"
2. "Lighting"
3. "Welcome light"
The setting is stored for the remote control currently in use.
Headlamp courtesy delay feature
The low beams stay lit for a short while after the ignition is switched off, if the lamps are switched off and the headlamp flasher is switched on.
Setting the duration
1. "Settings"
2. "Lighting"
3. "Pathway light.: s"
4. Set the duration.
The setting is stored for the remote control currently in use.
Automatic headlamp control
Switch position : the low beams are switched on and off automatically, e.g., in tunnels, in twilight or if there is precipitation. The indicator lamp in the instrument cluster lights up.
A blue sky with the sun low on the horizon can cause the lights to be switched on.
The low beams always stay on when the fog lamps are switched on.
Personal responsibility
The automatic headlamp control cannot
serve as a substitute for your personal judgment
in determining when the lamps should be
switched on in response to ambient lighting
conditions.
For example, the sensors are unable to detect fog or hazy weather. To avoid safety risks, you should always switch on the lamps manually under these conditions.◀
Daytime running lights
With the ignition switched on, the daytime running lights light up in position 0, or .
After the ignition is switched off, the parking lamps light up in position .
Activating/deactivating
1. "Settings"
2. "Lighting"
3. "Daytime running lamps"
The setting is stored for the remote control currently in use.
Roadside parking lamps
The vehicle can be illuminated on one side.
Switching on
With the ignition switched off, press the lever either up or down past the resistance point for approx. 2 seconds.
Switching off
Briefly press the lever to the resistance point in the opposite direction.
At a glance
1. Rear fog lamps 2. Front fog lamps 3. Automatic headlamp control, Adaptive Light Control , High-beam Assistant, Welcome lamps, daytime running lights 4. Lamps off, daytime running lights 5. ...Adaptive light control
The concept Adaptive light control is a variable headlamp control system that enables dynamic illumination of the road surface. Depending on the steering angle and other parameters, the light ...See also:
Cooling System – Drain, Flush, And Refill
If the engine coolant (antifreeze) is dirty or contains a
considerable amount of sediment, clean and flush with a
reliable cooling system cleaner. Follow with a thorough
rinsing to remove all de ...
Bluetooth Communication Link
Mobile phones have been found to lose connection to the
Uconnect™ Phone. When this happens, the connection
can generally be reestablished by switching the phone
off/on. Your mobile phone is re ...
2.5 L non-turbo models
1) Power steering fluid reservoir (page 11-27)
2) Manual transmission oil level gauge (MT) (page 11-23)
3) Clutch fluid reservoir (page 11-29)
4) Brake fluid reservoir (page 11-28)
5) Fuse box ( ...