Buick LaCrosse: Passenger Safety Belt 
Reminder Light - Safety Belt Reminders - Warning Lights, Gauges, and Indicators - Instruments and Controls - Buick LaCrosse Owners ManualBuick LaCrosse: Passenger Safety Belt Reminder Light

When the vehicle is started, this

When the vehicle is started, this light flashes and a chime may come on to remind front passengers to fasten their safety belt. Then the light stays on solid until the belt is buckled.

For more information see Passenger Airbag Status Indicator.

This cycle continues several times if the front passenger remains or becomes unbuckled while the vehicle is moving.

If the front passenger safety belt is buckled, neither the chime nor the light comes on.

The front passenger safety belt reminder light and chime may turn on if an object is put on the seat such as a briefcase, handbag, grocery bag, laptop, or other electronic device. To turn off the reminder light and/or chime, remove the object from the seat or buckle the safety belt.

    Driver Safety Belt Reminder Light
    There is a driver safety belt reminder light on the instrument panel cluster. When the vehicle is started, this light flashes and a chime may come on to remind the driver to fasten their ...

    Airbag Readiness Light
    This light shows if there is an electrical problem. The system check includes the airbag sensor(s), passenger sensing system, the pretensioners, the airbag modules, the wiring, and the crash ...

    See also:

    Operating UHP Using Voice Control
    The voice control of the UHP system enables you to operate several functions of the mobile phone using your voice. The UHP system uses voice commands to control the system and dial phone n ...

    Supplemental Active Head Restraints (AHR) — If Equipped
    These head restraints are passive, deployable components, and vehicles with this equipment cannot be readily identified by any markings, only through visual inspection of the head restraint. The ...

    Listing Stored Numbers
    The list command will list all the stored numbers and name tags. Using the “List” Command 1. Press . The system responds “Ready,” followed by a tone. 2. Say “Directory.”. 3. Say ...