Nissan Maxima: Programming HomeLink for Canadian customers
Prior to 1992, D.O.C. regulations required handheld transmitters to stop transmitting after 2 seconds.
To program your hand-held transmitter to HomeLink, continue to press and hold the HomeLink button (see steps 2 - 4 under Programming HomeLink) while you press and repress (cycle) your hand-held transmitters every 2 seconds until the indicator light flashes rapidly (indicating successful programming).
NOTE:
When programming a garage door opener, etc., it is advised to unplug the device during the cycling process to prevent possible damage to the garage door opener components.
Programming HomeLink
1. To begin, press and hold the two outer HomeLink buttons (to clear the memory) until the indicator light (1) blinks (after 20 seconds). Release both buttons. 2. Position the end of the hand-hel ...Operating the HomeLink universal transceiver
The HomeLink Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply press the appropriate programmed HomeLink Universal Transceiver button. Th ...See also:
Repairing stone chips
1. Place a strip of masking tape over the damaged surface. Pull the tape off
so that any loose flakes of paint adhere to it.
2. Thoroughly mix the primer and apply it with a small brush.
3. When ...
Selecting the correct oil
It is essential to choose the correct grade, quality
and viscosity engine oil to ensure satisfactory
engine life and performance. See “Capacities
and recommended fuel/lubricants” earlier in thi ...
To Play the Radio
The band and frequency that the
radio was last tuned to are displayed.
To change bands, press the AM or
FM button. On the FM band, ST will
be displayed if the station is
broadcasting in stere ...