Buick LaCrosse: Programming the Power
Windows
If the battery on the vehicle has been recharged, disconnected, or is not working, you will need to reprogram each front power window for the express-up feature to work.
Before reprogramming, replace or recharge the vehicle's battery.
To program each front window:
1. With the ignition in ON/RUN or ACC/ACCESSORY, or in Retained Accessory Power (RAP), close all doors.
2. Press and hold the power window switch until the window is fully open.
3. Pull the power window switch up until the window is fully closed.
4. Continue holding the switch up for approximately two seconds after the window is completely closed.
The window is now reprogrammed.
Repeat the process for the other windows.
Rear Window Lockout
Rear Window Lockout
This feature prevents the rear
passenger windows from operating,
except from the driver position.
Press o to activate the rear
window lockout switch. The LED (A)
comes ...
Sun Visors
Sun Visors
Pull the sun visor down to block
glare. Detach the sun visor from the
center mount to pivot to the side
window, or to extend along the rod,
if available. ...
See also:
Engine compartment check locations
QR25DE engine
1. Power steering fluid reservoir
2. Engine oil filler cap
3. Brake fluid reservoir/Clutch fluid
reservoir (M/T model)
4. Air cleaner
5. Fuse block
6. Battery
7. Fuse/Fusible l ...
Engine Oil Life System
The engine oil life system calculates engine oil life based on vehicle use and displays the CHANGE ENGINE OIL SOON message when it is time to change the engine oil and filter.
The oil life system sho ...
Trunk lamp
The trunk room lamp comes on when the trunk is opened.
CAUTION
The trunk lamp comes on as long as the trunk lid is open. To prevent unnecessary
charging system drain, close the trunk lid securel ...