Nissan Altima: Programming trouble-diagnosis
If the HomeLink does not quickly learn the handheld transmitter information:
● replace the hand-held transmitter batteries with new batteries.
● position the hand-held transmitter with its battery area facing away from the HomeLink surface.
● press and hold both the HomeLink and hand-held transmitter buttons without interruption.
● position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink is not programmed within that time, try holding the transmitter in another position – keeping the indicator light in view at all times.
If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone numbers are located in the Foreword of this manual.
Operating the HomeLink universal transceiver
The HomeLink Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply press the appropriate programmed HomeLink Universal Transceiver button. Th ...Clearing the programmed information
Individual buttons cannot be cleared. However, to clear all programming, press and hold the two outside buttons and release when the indicator light begins to flash (approximately 20 seconds). ...See also:
Cruise set switch indicator
light
The light comes on while the vehicle speed is
controlled by the cruise control system. If the light
blinks while the engine is running, it may indicate
the cruise control system is not functionin ...
Rear CD/DVD player
1 CD/DVD slot
2 Eject CD/DVD
3 On/off, right
4 Headphone connection, right
5 RCA sockets
6 Headphone connection, left
7 On/off, left ...
Cleaning genuine wood and trim
elements
•► Wipe the wooden trim and trim pieces with
a damp, lint-free cloth, e.g. a microfiber
cloth.
•► Heavy soiling: use car care and cleaning
products recommended and approved by
...