Nissan Maxima: Programming trouble-diagnosis
If the HomeLink does not quickly learn the handheld transmitter information:
- replace the hand-held transmitter batteries with new batteries.
- position the hand-held transmitter with its battery area facing away from the HomeLink surface.
- press and hold both the HomeLink and hand-held transmitter buttons without interruption.
- position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink is not programmed within that time, try holding the transmitter in another position keeping the indicator light in view at all times.
If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone numbers are located in the Foreword of this manual.
Operating the HomeLink universal transceiver
The HomeLink Universal Transceiver (once programmed) may now be used to activate
the garage door, etc. To operate, simply press the appropriate programmed HomeLink
Universal Transceiver button. Th ...
Clearing the programmed information
Individual buttons cannot be cleared. However, to clear all programming, press
and hold the two outside buttons and release when the indicator light begins to
flash (approximately 20 seconds). ...
See also:
Engine
Display messages
Possible causes/consequences and •► Solutions
Check Coolant
Level See
Operator's Manual
The coolant level is too low.
•► Add coolant, observing ...
Recommended lubricants and capacities
To help achieve proper engine and powertrain performance and durability, use
only lubricants of the proper quality. The correct lubricants also help promote
engine efficiency that results in impro ...
Wheel Replacement
Replace any wheel that is bent, cracked, or badly rusted or corroded. If wheel nuts keep coming loose, the wheel, wheel bolts, and wheel nuts should be replaced.
If the wheel leaks air, replace it.
...
