Subaru Legacy: PTY (Program type) group tuning (only FM reception)
Press the “PTY/CAT” button to change to the PTY selection mode. At this time, the PTY group that you are currently listening to will be displayed for 10 seconds. In PTY selection mode, “PTY SEL” is displayed on the screen.
PTY (Program type) group selection
In PTY selection mode, press the “PTY” button “” or “” to change the PTY group by one step at a time.
Pressing “” changes the PTY group up by one step. Pressing “” changes the PTY group down by one step. This operation only changes the display. It does not change the station that is currently being received.
Seek in PTY (Program type) group
In the PTY selection mode, when the desired PTY group has been selected, pressing the “SEEK” button “” or “” seeks within that PTY group. In this case, “PTY SEEK” is displayed on the screen. Pressing “” seeks up. Pressing “” seeks down.
The control function returns to the normal mode after approximately 10 seconds.
Scan tuning (SCAN)
If you press the “SCAN” button, the radio will switch to the scan mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop at the station for ...RDS text display
If the PS (Program Service Name) and/or RT (Radio Text) are available, pressing the “TEXT” button changes the display among PS, RT and frequency. The initial setting is “PS”. NOTE ` ...See also:
GM Mobility Reimbursement Program
This program is available to qualified applicants for cost reimbursement of eligible aftermarket adaptive equipment required for the vehicle, such as hand controls or a wheelchair/ scooter lift for ...
Checking the coolant level
Check the coolant level at each fuel stop.
1. Check the coolant level on the outside of the reservoir while the engine is
cool.
2. If the level is close to or lower than the “LOW” level mark ...
Blower Control
For full automatic operation or for
automatic blower operation, turn the
knob to the AUTO position. In manual
mode there are seven blower speeds
that can be individual selected. In off
pos ...