Volvo S60: Putting ACC in standby mode
Before ACC can be used to regulate speed and/or the distance to a vehicle ahead, it must first be put in standby mode.
To do so:
Press .
The symbol appears in the display and parentheses (---) indicate that ACC is in standby mode.
NOTE
The driver's door must be closed and the driver's seat belt must be fastened before ACC can be put in active mode. If the driver's seat belt is taken off or if the driver's door is opened, ACC will return to standby mode.
Operation
Controls and display 1 - Resume previous settings, increase speed (each additional press increases speed by 2 - 1 mph (approximately 2 km/h). 3 - Standby mode on/off 4 - Set time interval 5 ...Setting a speed
Once ACC has been put in standby mode, use the or buttons to store (set) the vehicle's current speed. This puts the system in active mode. The set speed, for example 55 mph, is shown in th ...See also:
Vehicle Phonebook
This vehicle has two phonebooks available for your use. Depending on your phone,
the system may automatically download your entire cell phones phonebook into the
Handset Phonebook . For the deta ...
Cooling system
WARNING
Never attempt to remove the radiator cap until the engine has been shut off and
has cooled down completely. Since the coolant is under pressure, you may suffer
serious burns from a spray ...
Vehicle Dynamic Control (VDC) system
The Vehicle Dynamic Control (VDC) system uses various sensors to monitor driver
inputs and vehicle motion. Under certain driving situations, the system will control
braking and engine output to he ...