BMW 5 Series: Reassigning individual programs
1. Switch on the ignition.
2. Hold the hand-held transmitter a distance of
approx. 1 to 3 in/2.5 to 8 cm from the memory
buttons.
The required distance depends on the
manual transmitter.
3. Hold down the memory button of the
integrated universal remote control.
4. If the LED flashes slowly after approx.
20 seconds, press the transmit button on
the hand-held transmitter.
5. Release both buttons when the LED flashes
rapidly.
If the LED does not flash rapidly after approx.
60 seconds, change the distance and repeat
the step.
Canada: if the LED is not flashing rapidly after
approx. 60 seconds, change the distance and
repeat the step, or, if the programming was interrupted
by the hand-held transmitter, hold
down the memory button and press and release
the button on the hand-held transmitter again
for 2 seconds.
Programming
▷ LED, arrow 1. ▷ Memory buttons, arrow 2. Fixed-code hand-held transmitters 1. Switch on the ignition. 2. Initial setup: Press the two outer memory buttons 1 and 3 for approx. 20 ...Deleting all stored programs
Press the two outer memory buttons for approx. 20 seconds until the LED flashes rapidly. All stored programs are deleted. The programs cannot be deleted individually ...See also:
Using a warm water washer
● Keep a good distance of 12 in (30 cm) or more between the washer nozzle and
the vehicle.
● Do not wash the same area continuously.
● If a stain will not come out easily, wash b ...
Adding DEF
WARNING
Make sure
- DEF does not come into contact with skin,
eyes, or clothing
- to keep DEF out of the reach of children
If you and/or others have come into contact
with D ...
Using KEYLESS-GO
The KEYLESS-GO key must be outside the
vehicle. All the doors must be closed.
•► Touch recessed sensor surface 1 on the
door handle until the side windows and the
sliding sunroof or t ...