Buick LaCrosse: Reducing Speed While Using
Cruise Control
If the cruise control system is already activated:
• Move the thumbwheel toward SET/− and hold until the desired lower speed is reached, then release it.
• To slow down in small amounts, move the thumbwheel toward SET/− briefly and then release it.
Each time this is done, the vehicle goes about 1.6 km/h (1 mph) slower.
Increasing Speed While Using
Cruise Control
If the cruise control system is
already activated:
• Move the thumbwheel up toward
RES/+ and hold it until the
vehicle accelerates to the
desired speed, and then
release it.
• To incre ...
Passing Another Vehicle While
Using Cruise Control
Use the accelerator pedal to
increase the vehicle's speed. When
you take your foot off the pedal, the
vehicle will slow down to the
previous set cruise control speed. ...
See also:
Check battery and cables
Winter puts additional burdens on the battery system. Visually inspect the battery
and cables as described in section 7. The level of charge in your battery can be
checked by an authorized HYUNDAI ...
Fault tracing and actions
If the message Radar blocked See manual is displayed, this means that the radar
signals from the sensor have been obstructed and that a vehicle ahead cannot be
detected.
This, in turn, means that ...
Programming HomeLink
1. To begin, press and hold the two outer HomeLink buttons (to clear the memory)
until the indicator light (1) blinks (after 20 seconds). Release both buttons.
2. Position the end of the hand-hel ...
