Subaru Legacy: Remote transmitter program
New transmitters can be programmed to the remote engine start system in the event that a transmitter is lost, stolen, damaged or additional transmitters are desired (the system will accept up to eight transmitters). New remote engine start transmitters can be programmed according to the following procedure.
1. Open the driver’s door (the driver’s door must remain opened throughout the
entire process).
2. Depress and hold the brake pedal.
3. Turn the ignition switch to “ON” then “LOCK”, back to “ON” then “LOCK”, then
back to “ON” again and leave the ignition “ON” throughout the programming process.
4. The system will flash the side marker lights, tail lights and front position
lights and honk the horn three times, indicating that the system has entered the
transmitter learn mode.
5. Press and release the “ ” button on the transmitter that you want to program.
6. The system will flash the side marker lights, tail lights and front position
lights and honk the horn one time, indicating that the system has learned the transmitter.
Upon successful programming, the remote start confirmation transmitter button will
flash one time.
7. Repeat step 5 for any additional transmitters (the system will accept up to eight
transmitters).
8. The system will exit the transmitter learn mode if the key is turned to the “LOCK”
position, the door is closed or after 2 minutes.
Service mode
In service mode, the remote engine start function is temporarily disabled to prevent the system from unexpectedly starting the engine while being serviced. To engage or disengage service mode: 1. ...System maintenance
NOTE In the event that the vehicle’s battery is replaced, discharged or disconnected, it will be necessary to start the vehicle a minimum of one time using the key prior to activating the remot ...See also:
Towing a Trailer
Your vehicle has been designed
primarily to carry passengers and
their cargo. You can also use it to
tow a trailer if you carefully observe
the load limits, use the proper
equipment, and fol ...
Symbols and messages in the display
...
Storing the current speed or calling up
a stored speed
WARNING
The set speed stored in memory should only
be set again if prevailing road conditions and
legal speed limits permit. Possible
acceleration or deceleration differences
arising from ...