Volvo S60: Removing the cover to access the bulbs
NOTE
Before starting to replace a bulb, see page 306.
1. Loosen the cover's four retaining screws with the tool (1) provided in the vehicle's tool kit (see page 290). The screws should not be removed completely.
CAUTION
Use the tool from the vehicle's tool kit to loosen the screws. A screwdriver or other sharp object could scratch the headlight.
2. Push the cover to the side.
Reinstall the cover in the reverse order.
Headlight housing
The entire headlight housing must be lifted out when replacing all front bulbs. CAUTION Never touch the glass of bulbs with your fingers. Grease and oils from your fingers vaporize in the heat ...Low beam, Halogen
1. Remove the headlight housing from the vehicle (see page 306). 2. Remove the cover over the bulbs (see page 308). 3. Unplug the connector from the bulb. 4. Remove the bulb by pulling it straigh ...See also:
ECO gauge
1) U.S.-spec. models
2) Except U.S.-spec. models
The ECO gauge shows the difference between the average rate of fuel consumption
and the current rate of fuel consumption. Using the average rate ...
Auto Fan Speed
This will allow you to select the
automatic fan speed. It can be
adjusted to run lower or higher than
normal.
Press SELECT when Auto Fan
Speed is highlighted to open the
menu. Turn the Menu ...
Activating/deactivating warning signals
The collision warning system’s visual signals are activated automatically when
the engine is started if the collision warning system is switched on.
The audible warning signal can be activated/ d ...