Honda Accord: Replacing a Front Side Marker Light Bulb
1. To change the bulb on the driver’s side, start the engine, turn the steering wheel all the way to the right, then turn off the engine. To change the bulb on the passenger’s side, turn the steering wheel to the left.
2. Use a flat-tip screwdriver to remove the two holding clips from the inner fender.
3. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise.
4. Pull the burned out bulb straight out of its socket.
Push the new bulb straight into the socket until it bottoms.
5. Insert the socket back into the headlight assembly. Turn it clockwise to lock it in place.
6. Turn on the lights to make sure the new bulb is working.
7. Reinstall the inner fender cover.
Then reinstall the holding clips, and lock them in place by pushing on their centers.
Replacing a Front Turn Signal/Parking Light Bulb
1. Open the hood.
To change the turn signal bulb on
the passenger’s side, remove the
engine coolant reserve tank by
pulling it out of its stay.
Driver’s side on V6 models
Remove t ...
Replacing Rear Bulbs
1. Open the trunk.
Remove the screws in the center
of each of the two fasteners on the
side of the trunk lining. Pull the
lining back.
2. Determine which of the three
bulbs is burned out: ...
See also:
Engine Exhaust (Carbon Monoxide)
WARNING:
Do not drive your vehicle if you smell exhaust gas inside the vehicle:
Engine exhaust gas is dangerous. This gas contains carbon monoxide (CO), which
is colorless, odorless, and poisonous ...
Headlight housing
The entire headlight housing must be lifted out when replacing all front bulbs.
CAUTION
Never touch the glass of bulbs with your fingers. Grease and oils from your fingers
vaporize in the heat ...
Rain sensor
The concept
The time between wipes is controlled automatically
and depends on the intensity of the rainfall.
The sensor is located on the windshield, directly
in front of the interior rearview m ...
