Subaru Legacy: Replacing bulbs
WARNING
Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down, Otherwise, there is the risk of sustaining a burn injury.
CAUTION
Replace any bulb only with a new bulb of the specified wattage. Using a bulb of different wattage could result in a fire. For the specified wattage of each bulb, refer to “Bulb chart” F12-14.
- Headlight
- Front turn signal light
- Front position light
- Front fog light (if equipped)
- Rear combination lights
- Tail/Back-up light (Outback)
- License plate light
- Dome light
- Map light
- Vanity mirror light
- Door step light
- Cargo area light (Outback)
- Trunk light (Legacy)
- Other bulbs
Installation of accessories
Always consult your SUBARU dealer before installing fog lights or any other electrical equipment in your vehicle. Such accessories may cause the electronic system to malfunction if they are incorr ...Headlight
CAUTION Halogen headlight bulbs become very hot while in use. If you touch the bulb surface with bare hands or greasy gloves, fingerprints or grease on the bulb surface will develop into hot spot ...See also:
Pinch protection system
If the closing force when closing the glass sunroof
exceeds a certain value, the closing movement
is stopped, beginning at approximately the
middle of the opening in the roof, or from the
tilt ...
Steering Wheel Controls
Steering Wheel Controls
For vehicles with audio steering
wheel controls, some audio controls
can be adjusted at the steering
wheel.
(Push to Talk): For vehicles
with a Bluetooth®, OnStar ...
Trailer Towing
The Mazda6 is not designed for towing.
Never tow a trailer with your Mazda6. ...