Nissan Altima: Reprogramming a single HomeLink button
To reprogram a HomeLink Universal Transceiver button, complete the following.
1. Press and hold the desired HomeLink button. Do not release the button until step 4 has been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface.
3. Press and hold the hand-held transmitter button.
4. The HomeLink indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons.
The HomeLink Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink button that was just programmed. This procedure will not affect any other programmed HomeLink buttons.
Rolling code programming
Rolling code garage door openers (or other rolling
code devices) which are “code protected”
and manufactured after 1996, may be determined
by the following:
● Reference the garage door o ...
If your vehicle is stolen
If your vehicle is stolen, you should change the
codes of any non-rolling code device that has
been programmed into HomeLink . Consult the
Owner’s Manual of each device or call the manufacturer
...
See also:
Vehicle loading information
WARNING:
- It is extremely dangerous to ride in a cargo area inside a vehicle. In a collision,
people riding in these areas are more likely to be seriously injured or killed.
- Do not allow people ...
Fuel-Filler Lid and Cap
WARNING:
When removing the fuel cap, loosen the cap slightly and wait for any hissing
to stop. Then remove it:
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness if ingested.
...
If the cruise control indicator light comes on in yellow
Press the “ON-OFF” button once to deactivate the system, and then press
the button again to reactivate the system.
If the cruise control speed cannot be set or if the cruise control cancels
i ...
