Buick LaCrosse: Ride Control System Messages - Vehicle Messages - Instruments and Controls - Buick LaCrosse Owners ManualBuick LaCrosse: Ride Control System Messages

ALL WHEEL DRIVE OFF

This message displays when the All-Wheel Drive (AWD) System has been turned off. See All-Wheel Drive.

SERVICE ALL WHEEL DRIVE SYSTEM

This message displays when there is a problem with the All-Wheel Drive (AWD) System. See your dealer for service.

SERVICE REAR AXLE

This message displays when there is a problem with the All-Wheel Drive (AWD) System. See your dealer for service.

SERVICE TRACTION CONTROL

This message displays when there is a problem with the Traction Control System (TCS). When this message is displayed, the system will not limit wheel spin. Adjust your driving accordingly. See your dealer for service.

SERVICE STABILITRAK

This message displays if there is a problem with the StabiliTrak system.

If this message appears, try to reset the system. Stop; turn off the engine for at least 15 seconds; then start the engine again. If this message still comes on, it means there is a problem. See your dealer for service. The vehicle is safe to drive, however, you do not have the benefit of StabiliTrak, so reduce your speed and drive accordingly.

SPORT MODE ON

This message displays when using the selective ride control. See Selective Ride Control for more information.

TRACTION CONTROL OFF

This message displays when the Traction Control System (TCS) is turned off. Adjust your driving accordingly.

    Object Detection System Messages
    PARK ASSIST OFF This message displays when the park assist system has been turned off or when there is a temporary condition causing the system to be disabled. See Ultrasonic Parking Assist ...

    Anti-theft Alarm System Messages
    THEFT ATTEMPTED This message displays if the vehicle detects a tamper condition. ...

    See also:

    Toggling Between Calls
    If two calls are in progress (one active and one on hold), press the button until you hear a single beep, indicating that the active and hold status of the two calls have switched. Only one c ...

    The Blind Spot Monitor is operational when
    The BSM main switch is set to on and vehicle speed is greater than about 25 mph (40 km/h) ...

    Reading out loud
    Text messages, e-mails, appointment entries, tasks, and notes can be read out loud. 1. Select the desired message, appointment, task, or note. 2. Select the symbol. The following options are a ...