Nissan Altima: Rolling code programming
Rolling code garage door openers (or other rolling code devices) which are “code protected” and manufactured after 1996, may be determined by the following:
● Reference the garage door opener Owner’s Manual for verification.
● The hand-held transmitter appears to program the HomeLink Universal Transceiver but does not activate the garage door.
● Press and hold the trained HomeLink button. If the garage door opener has the rolling code feature, the HomeLink indicator light will flash rapidly, then remain on after 2 seconds. To program the HomeLink Universal Transceiver to a garage door opener with the rolling code feature, follow these instructions after completing the “Programming HomeLink ” (the aid of a second person may make the following procedures quicker and easier).
1. Locate the training button on the garage door opener motor unit. Exact location and color of the button may vary by garage door opener brand. If there is difficulty locating the training button, reference the garage door opener Owner’s Manual.
2. Press the training button on the garage door opener motor unit (which may activate a training light).
NOTE:
Following step 2, there are 30 seconds in which to initiate step 3.
3. Firmly press and release the programmed HomeLink button a second time to complete the training process. (Some garage door openers may require you to do this procedure a third time to complete the training.)
The garage door opener should now recognize the HomeLink Universal Transceiver and activate when the HomeLink button is pressed. The remaining two buttons may now be programmed (if not yet programmed, follow steps 2 through 4 in the “Programming HomeLink ” procedures earlier in this section).
Clearing the programmed information
Individual buttons cannot be cleared. However, to clear all programming, press and hold the two outside buttons and release when the indicator light begins to flash (approximately 20 seconds). ...Reprogramming a single HomeLink button
To reprogram a HomeLink Universal Transceiver button, complete the following. 1. Press and hold the desired HomeLink button. Do not release the button until step 4 has been completed. 2. When the ...See also:
Power Sunroof — If Equipped
The sunroof controls are mounted between the dome/
reading lights.
Power Sunroof Switch
WARNING!
• Never leave children in a vehicle with the key in
the ignition switch. Occupants, particul ...
Hood
(1) Pull the hood lock release handle located below the driver side instrument
panel. The hood will spring up slightly.
(2)- Push the lever at the front of the hood to the side as illustrat ...
Deactivating/activating the ECO start/
stop function
Example: ECO button
If indicator lamp 2 is off, the ECO start/
stop function has been deactivated
manually or as the result of a malfunction.
The engine will then not be switched off
automat ...