Buick LaCrosse: SBZA Error Messages - Side Blind Zone Alert (SBZA) - Object Detection Systems - Driving and Operating - Buick LaCrosse Owners ManualBuick LaCrosse: SBZA Error Messages

The following messages may appear on the infotainment display:

SIDE BLIND ZONE ALERT SYSTEM OFF: This message indicates that the driver has turned the system off.

SIDE BLIND ZONE SYS.

UNAVAILABLE: This message indicates that the SBZA system is disabled because the sensor is blocked and cannot detect vehicles in the blind zone. The sensor may be blocked by mud, dirt, snow, ice, or slush. This message may also activate during heavy rain or due to road spray. The vehicle does not need service. For cleaning, see Exterior Care.

SERVICE BLIND ZONE ALERT SYSTEM: If this message appears, both SBZA displays will remain on indicating there is a problem with the SBZA system. If these displays remain on after continued driving, the system needs service. Take the vehicle to your dealer.

    When the System Does Not Seem to Work Properly
    Occasional missed alerts can occur under normal circumstances and will increase in wet conditions. The system does not need to be serviced due to an occasional missed alert. The number of mi ...

    FCC Information
    See Radio Frequency Statement for information regarding Part 15 of the Federal Communications Commission (FCC) rules and Industry Canada Standards RSS-GEN/210/220/310. ...

    See also:

    Parking lamps/low beams, headlamp control
    General information If the driver door is opened with the ignition switched off, the exterior lighting is automatically switched off at the following switch settings: 0, , Parking lamps Swit ...

    Cleaning the seat covers
    Do not use microfiber cloths to clean genuine leather, artificial leather or Alcantara┬« covers. If used often, these can damage the cover. Observe the following when cleaning:  - clean g ...

    Starting the Vehicle
    1. Aim the RKE transmitter at the vehicle. 2. Press and release . 3. Immediately after completing Step 2, press and hold until the turn signal lamps flash, or for about two seconds if the v ...