Mazda Mazda6: Seat Belt Warning Light/Beep - Essential Safety Equipment - Mazda6 Owners ManualMazda Mazda6: Seat Belt Warning Light/Beep

The seat belt warning light illuminates and a beep sound will be heard if the

The seat belt warning light illuminates and a beep sound will be heard if the driver's seat belt is not fastened when the ignition is switched ON.

Conditions of operation

Condition Result
The driver's seat belt is not fastened when the ignition is switched ON. The warning light illuminates for about 1 minute and a beep sound will be heard for about 6 seconds.
The driver's seat belt is fastened while the warning light and the beep sound are activated. The warning light turns off and the beep sound stops.
The driver's seat belt is fastened before the ignition is switched ON. The warning light will not illuminate and the beep sound will not be heard.

Belt Minder

NOTE:

The belt minder can be deactivated. Consult an Authorized Mazda Dealer to deactivate or restore the seat belt minder.

Driver seated/Front passenger not seated

The belt minder is a supplemental warning to the seat belt warning function.

If the driver's seat belt is not fastened when the ignition is switched ON, the warning light/beep operates to give you further reminders according to the chart below.

Once the beep sound is heard, it continues sounding even if the vehicle speed

Once the beep sound is heard, it continues sounding even if the vehicle speed lowers to 20 km/h (12 mph) or less until the seatbelt is fastened or the beep sound period has passed.

Driver seated/Front passenger seated

The seat belt warning function reminds the front passenger to fasten the seat belt according to the chart below.

Placing heavy items on the front passenger seat may cause the front passenger

Placing heavy items on the front passenger seat may cause the front passenger seat belt warning function to operate depending on the weight of the item.

Once the beep sound is heard, it continues sounding even if the vehicle speed lowers to 20 km/h (12 mph) or less until the seatbelt is fastened or the beep sound period has passed.

NOTE:

- To allow the front passenger seat weight sensor to function properly, do not place and sit on an additional seat cushion on the front passenger seat. The sensor may not function properly because the additional seat cushion could cause sensor interference.

- When a small child sits on the front passenger seat, it is possible that neither the warning light nor the warning beep operate.

    Seat Belt Extender
    If your seat belt is not long enough, even when fully extended, a seat belt extender may be available to you at no charge from your Authorized Mazda Dealer. This extender will be only for you and f ...

    Child Restraint Precautions
    Mazda strongly urges the use of child-restraint systems for children small enough to use them. You are required by law to use a child-restraint system for children in the U.S. and Canada. Check ...

    See also:

    Emergency fuel filler lid release
    An emergency fuel filler lid release is located in the luggage compartment, on the left side. If the fuel filler lid does not open using the remote fuel filler lid release, you can open it manua ...

    Tunnel console
    1 - Storage compartment (for CDs, etc.) under armrest, AUX input/USB connector. 2 - Includes cup holder for driver and passenger, 12-volt socket and small storage compartment. ...

    Protecting Small Children
    Child Seat Type Many states, Canadian provinces and territories allow a child one year of age or older who also meets the minimum size and weight requirements to transition from a rear-fa ...