Subaru Legacy: Security indicator light
The security indicator light deters potential thieves by indicating that the vehicle is equipped with an immobilizer system. It begins flashing approximately 60 seconds after the ignition switch is turned from the “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out.
If the security indicator light does not flash, the immobilizer system may be malfunctioning. If this occurs, contact your SUBARU dealer as soon as possible. In case an unauthorized key is used (e.g. an imitation key), the security indicator light illuminates.
NOTE
Even if the security indicator light flashes irregularly or its fuse blows (the light does not flash if its fuse is blown), the immobilizer system will function normally.
Security ID plate
1) Key number plate 2) Security ID plate The security ID is stamped on the security ID plate attached to the key set. Write down the security ID and keep it in another safe place, not in the veh ...Key replacement
Your key number plate and security ID plate will be required if you ever need a replacement key made. Any new key must be registered for use with your vehicle’s immobilizer system before it can ...See also:
Standard Mode command list
Category Command:
Phone Command:
Navigation Command:
Information Command:
Audio Command:
...
Fuel filter
A clogged filter can limit the speed at which the vehicle may be driven, damage
the emission system and cause multiple issues such as hard starting. If an excessive
amount of foreign matter accumu ...
Rear window wiper and washers
Intermittent wiping
Pull the lever towards the steering wheel.
Reverse gear wipe
The rear wiper will be activatedautomatically when selecting reverse gear, if
• the rear wiper is not already swi ...