Honda Accord: Selecting a Child Seat
When buying a child seat, you need to choose either a conventional child seat, or one designed for use with the Lower Anchors and Tethers for CHildren (LATCH) system.
Conventional child seats must be secured to a vehicle with a seat belt, whereas LATCH-compatible seats are secured by attaching the seat to hardware built into the two outer seating positions in the back seat.
Since LATCH-compatible child seats are easier to install and reduce the possibility of improper installation, we recommend selecting this style.
In seating positions and vehicles not equipped with LATCH, a LATCHcompatible child seat can be installed using a seat belt.
Whatever type of seat you choose, to provide proper protection, a child seat should meet three requirements:
1. The child seat should meet Federal Motor Vehicle Safety Standard 213 or Canadian Motor Vehicle Safety Standard 213.
Look for FMVSS 213 or CMVSS 213 on the box.
2. The child seat should be of the proper type and size to fit the child.
Rear-facing for infants, forwardfacing for small children.
3. The child seat should fit the vehicle seating position (or positions) where it will be used.
Before purchasing a conventional child seat, or using a previously purchased one, we recommend that you test the seat in the specific vehicle seating position or positions where the seat will be used.
Protecting Small Children
Child Seat Type Many states, Canadian provinces and territories allow a child one year of age or older who also meets the minimum size and weight requirements to transition from a rear-fa ...Installing a Child Seat
After selecting a proper child seat and a good place to install the seat, there are three main steps in installing the seat: 1. Properly secure the child seat to the vehicle. All child seats ...See also:
Adjusting the set speed
To change the set speed, operate the lever until the desired set
speed is obtained.
1 Increases the speed
2 Decreases the speed
Fine adjustment: Momentarily
move the lever in the desired
di ...
Adding Washer Fluid
The fluid reservoir for the windshield washers is located
in the engine compartment. Be sure to check the fluid
level in the reservoir at regular intervals. Fill the reservoir
with windshield wa ...
Conditions in Which Remote Start
Will Not Work
The remote start will not operate if:
• The key is in the ignition (key
access) or the ignition is in any
position other than OFF (keyless
access).
• The transmitter is in the vehicle
(k ...