Subaru Legacy: Selecting audible signal operation
Using an electronic chirp, the system will give you an audible signal when the doors lock and unlock. If desired, you may turn the audible signal off.
To deactivate the audible signal, perform the following procedure. You can also use the same steps to restore the function.
1. Sit in the driver’s seat and shut all doors and the rear gate.
2. Press the unlock side of the power door locking switch.
3. Insert the key into the ignition switch.
4. While holding down the unlock side of the power door locking switch, pull the
key out and re-insert it into the ignition switch at least 5 times within 10 seconds
after performing step 2.
5. Open and close the driver’s door within 10 seconds after performing step 4.
6. To indicate completion of the setting, the turn signal lights flash 3 times and
the chirp sounds 3 times.
You may have the above procedure performed by your SUBARU dealer.
Sounding a panic alarm
To activate the alarm, press the “PANIC” button once. The horn will sound and the turn signal lights will flash. To deactivate the panic alarm, press any button on the remote transmitter. If ...Replacing the battery
CAUTION ● Do not let dust, oil or water get on or in the transmitter when replacing the battery. ● Be careful not to damage the printed circuit board in the transmitter when replacing ...See also:
Lighting Control
Headlights
Type A (Without
AUTO position)
Turn the headlight switch to turn the headlights, other exterior lights and dashboard
illumination on or off.
NOTE:
- If the light switch is left o ...
Hood
Opening the hood
WARNING
Do not pull the release lever while the vehicle
is in motion. Otherwise, the hood could be
forced open by passing air flow.
This could cause the hood to come loose ...
Seat belt
Problem
Possible causes/consequences and •► Solutions
After starting the
engine, the red seat
belt warning lamp lights
up for six seconds.
The seat belt warning lamp re ...