BMW 5 Series: Signal tones
When approaching an object, an intermittent tone is sounded that indicates the position of the object. For example, if an object is detected to the left rear of the vehicle, a signal tone sounds from the left rear speaker.
The shorter the distance to the object becomes, the shorter the intervals.
If the distance to a detected object is less than approx. 12 in/30 cm, a continuous tone is sounded.
If objects are located both in front of and behind the vehicle, an alternating continuous signal is sounded.
The intermittent tone is interrupted after approx.
3 seconds:
▷ If the vehicle stops in front of an object that
is detected by only one of the corner sensors.
▷ If moving parallel to a wall.
The signal tone is switched off:
▷ When the vehicle moves away from an object
by more than approx. 4 in/10 cm.
▷ When transmission position P is engaged.
Volume
You can set the volume of the PDC signal tone, The setting is stored for the remote control currently in use.
Switching on/off manually
Switching on/off manually
Press the
button.
▷ On: the LED lights up.<>
▷ Off: the LED goes out. ...
Visual warning
The approach of the vehicle to an object can be
shown on the Control Display. Objects that are
farther away are displayed on the Control Display
before a signal tone sounds.
A display appears a ...
See also:
Conditions under which the Blind Spot Monitor may not function correctly
●The Blind Spot Monitor may not detect vehicles correctly in the following
conditions:
• During bad weather such as heavy rain, fog, snow etc.
• When ice, mud etc. is attached to the rea ...
Consumer information
This consumer information has been prepared in accordance with regulations issued
by the National Highway Traffic Safety Administration of the U.S. Department of
Transportation. Your Hyundai deale ...
Map view
Selecting the map view
1. "Navigation"
2. "Map" ...
