Subaru Legacy: Sliding moonroof
1) Open
2) Close
Press the “OPEN/CLOSE” switch rearward to open the moonroof. The sun shade will also be opened together with the moonroof. For Outback, the moonroof will stop at a position approximately 0.8 in (2 cm) away from the fully opened position. Press the switch again to open the moonroof completely.
Press the “OPEN/CLOSE” switch forward to close the moonroof. To stop the moonroof at a selected midway position while opening or closing it, momentarily press the switch to the “OPEN” side or “CLOSE” side. After washing the vehicle or after it rains, wipe away water on the roof prior to opening the moonroof to prevent drops of water from falling into the passenger compartment.
NOTE
● For the sake of safety, it is recommended that you avoid driving with the moonroof
fully opened.
● If the moonroof cannot be closed through the switch operation because of system
failure, it can be closed manually using a hex-head wrench. For the procedure, refer
to “Moonroof
– if moonroof cannot be closed” F9-19.
Tilting moonroof
1) Raise 2) Lower The raising function will only operate when the moonroof is fully closed. The lowering function will only operate when the moonroof is raised. Press the rear side of the “UP ...Anti-entrapment function
When the moonroof senses a substantial enough object trapped between its glass and the vehicle’s roof during closure, it automatically moves back to the fully open position and stops there. The ...See also:
Playing and pausing tracks
Press (). ...
Vehicle finder function
Use this function to find your vehicle parked among many vehicles in a large
parking lot. Provided you are within 30 feet (10 meters) of the vehicle, pressing
the “” button three times in a 5- ...
To hook the top tether
CAUTION
Always remove the head restraint when mounting a child restraint system with
a top tether. Failure to do so may prevent the top tether from being fastened tightly.
Legacy
1. Fold down the ...