Toyota Camry: Switching the door unlock function
It is possible to set which doors the entry function unlocks using the wireless remote control.
Turn the “ENGINE START STOP” switch off.
When the indicator light on the key surface is not on, press and hold , , or for about 5 seconds while pressing and holding .
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least 5 seconds, and repeat step 2.)
Vehicles with an alarm system: To prevent unintended triggering of the alarm, unlock the doors using the wireless remote control and open and close a door once after the settings have been changed. (If a door is not opened within 60 seconds after is pressed, the doors will be locked again and the alarm will automatically be set.) In case that the alarm is triggered, immediately stop the alarm.
Security feature
If a door is not opened within approximately 60 seconds after the vehicle is unlocked, the security feature automatically locks the vehicle again. (However, depending on the location of the electr ...Battery-saving function
The battery-saving function will be activated in order to prevent the electronic key battery and the vehicle battery from being discharged while the vehicle is not in operation for a long time. ...See also:
Service Parts Identification Label
This label, located either in the glove box or the trunk area, has the following information:
► Vehicle Identification Number (VIN).
► Model designation.
► Paint information.
...
Air flow charts
The following charts show the button and dial
positions for MAXIMUM AND QUICK heating,
cooling or defrosting. The air recirculation
button should always be in the OFF position
for heating and defr ...
Dialing voicemail
The dialogue below enables you to call your voicemail to check any messages that
you may have received. Your voicemail phone number must be registered in the Bluetooth
function, see page ...