Subaru Legacy: Tachometer
The tachometer shows the engine speed in thousands of revolutions per minute.
CAUTION
Do not operate the engine with the pointer of the tachometer in the red zone. In this range, fuel injection will be cut by the engine control module to protect the engine from overrevving. The engine will resume running normally after the engine speed is reduced below the red zone.
NOTE
To protect the engine while the select lever is in the “P” or “N” position (for AT and CVT models) or the shift lever is in the neutral position (for MT models), the engine is controlled so that the engine speed may not become too high even if the accelerator pedal is pressed hard.
Double trip meter
1) Trip knob This meter displays the two trip meters when the ignition switch is in the “ON” position. The trip meter shows the distance that the vehicle has been driven since you last set ...Fuel gauge
1) Low fuel warning light The fuel gauge shows the approximate amount of fuel remaining in the tank. When the ignition switch is in the “LOCK” or “Acc” position, the fuel gauge shows “E ...See also:
SRS warning light
This warning light system monitors the airbag sensor assembly, front airbag
sensors, side and curtain shield airbag sensors, curtain shield airbag sensors,
driver's seat belt buckle switch, front ...
Lighting Control
Headlights
Type A (Without
AUTO position)
Turn the headlight switch to turn the headlights, other exterior lights and dashboard
illumination on or off.
NOTE:
- If the light switch is left o ...
Forward and backward adjustment
Pull the lever upward and slide the seat to the desired position. Then release
the lever and try to move the seat back and forth to make sure that it is securely
locked into place. ...