Buick LaCrosse: Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
A. Back-Up Lamp
B. Turn Signal Lamp
To replace one of these lamps:
1. Open the trunk. See Trunk.
2. Remove the fasteners and pull back the trunk trim.
3. Remove the four plastic wing nuts holding the taillamp assembly in place.
4. Pull out the taillamp assembly and disconnect the wiring harness.
5. Turn the bulb socket counterclockwise to remove it.
6. Pull the old bulb straight out of the bulb socket.
7. Reverse Steps 1 through 6 to install.
Uplevel Headlamp Assembly
The uplevel model vehicle has a high intensity discharge (HID) high/low beam, a dedicated DRL, and a parking/turn signal lamp on the headlamp assembly. See High Intensity Discharge (HID) Light ...License Plate Lamp
The license plate lamps for this vehicle are on the trunk lid. To replace one of these bulbs: 1. Open the trunk. See Trunk for more information. 2. Push the end on either of the lamp assembli ...See also:
Brake Pedal Travel
See your dealer if the brake pedal
does not return to normal height,
or if there is a rapid increase in
pedal travel. This could be a sign
that brake service might be
required. ...
Services Specific to Canadian-Purchased Vehicles
• Fuel delivery: Reimbursement
is approximately $5 Canadian.
Diesel fuel delivery may be
restricted. Propane and other
fuels are not provided through
this service.
• Lock-Out Service: Ve ...
Office
Vehicle equipment
All standard, country-specific and optional
equipment that is offered in the model series is
described in this chapter. Therefore, equipment
is also described that is not avai ...